Remote Probe(and all "remote" sensors) are shown as paused. The PRTG Probe Service is running. When I try to stop it, I get an error after five minutes. I can kill the "PRTG Probe.exe" prozess in Task Manager. Then it is possible to start the Probe Service again. The Probe is working for up to 48 hours but then paused again.
Remote Probe is shown as paused
Modified on 2025-06-10 11:30:12 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
when this occurs the next time, please send us some screenshots showing the issue via email to support@paessler.com
Thank you!
Apr, 2012 - Permalink