Hi, I am trying to auto-discover sensor on Cisco routers and it only discovers ping. These cisco routers have access-lists on them so only permit specific ports and protocols through. what port and protocols do I need to permit on the access-list for PRTG to get information from all the sensors that are available by default on Cisco routers? i.e other interfaces, Memory, CPU etc.. Thanks, Jaime
Auto discover through a firewall
Modified on 2025-06-10 11:32:15 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
usually it's at least SNMP on UDP Port 161 (on the target device).
best regards.
Mar, 2012 - Permalink