Is it possible to telnet out of PRTG to my Cisco devices? That would make perfect sense to me, simply right clicking on the Cisco device and telnet to the monitored device instead of leaving PRTG and starting a DOS telnet.
Telnet to Cisco devices
Modified on 2025-06-10 11:32:20 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
this is possible by defining 'Telnet' as a new Tool in the Enterprise Console.
best regards.
Mar, 2012 - Permalink