Hi, I am struggling to get snmpv3 and PRTG working for a Cisco router. Does PRTG rely on snmp information being sent to the PRTG server (traps)? Do you have an example cisco snmpv3 configuration that works with PRTG ? Thanks, Jaime
snmpv3 connection to Cisco router
Modified on 2025-06-10 11:32:53 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
it's not necessary to send traps to PRTG for the configuration of "normal" SNMP Polling. I'm afraid we also do not have guides on how to setup SNMPv3 on Cisco Devices. But You can use our SNMP Tester to assist with the troubleshooting.
best regards.
Feb, 2012 - Permalink