Subject more or less says it all - when using the quick select boxes and then pausing a group of sensors, I'd like to disable it popping up the dialog asking for a message. Ie, just pause immediately. Thanks, Tim
Is there a way to disable the prompt for a message when pausing a sensor?
Modified on 2025-06-10 11:36:47 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
hallo,
at the moment it can not be turned of, sorry.
Jan, 2012 - Permalink