Multiple sensors with sFfow
Modified on 2025-06-10 11:39:33 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
We are using the free version of PRTG looking to maybe buy the full version.
My question is:
I have HP Procurve switches that can only have 3 sFlow instances running at once. I can enable multiple ports for each instance however (including ALL). If I did that, would PRTG see all the ports as 1 sensor for the device and then 1 graph? How can I get the whole switch monitored but break up each port?
Thanks for helping!
Patrick
Article Comments
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
you could try using the [Interface]-Filter (see PRTG 9 Manual: Filter Rules for xFlow and Packet Sniffer Sensors) to use several Sflow-Sensors all listening to the same flows but then each filtering for a different interface.
best regards.
Nov, 2011 - Permalink