Duplicate node ID
Modified on 2025-06-10 11:39:38 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I had a PRTG cluster with a master and a failover. For various resons I wanted to swap their roles. For that I made both stand-alone and then created the new cluster on the new master node. On the failover node I said to join the cluster. This doesn't work however and I notice that both servers have the same node ID's which doesn't seem right.
I'm running the latest version 9.1.4
Article Comments
Dear Jeffrey,
please try shutting down both nodes. Then completely uninstall PRTG from the failover-node and also make sure that all registry-settings are removed and gone (see How and where does PRTG store its data? for details). Then restart the master node and please install PRTG anew on the failover-node and do join the PRTG cluster anew.
best regards.
Nov, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Jeffrey,
please try shutting down both nodes. Then completely uninstall PRTG from the failover-node and also make sure that all registry-settings are removed and gone (see How and where does PRTG store its data? for details). Then restart the master node and please install PRTG anew on the failover-node and do join the PRTG cluster anew.
best regards.
Nov, 2011 - Permalink