How to receive link down traps
Modified on 2025-06-10 11:52:40 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi,
i have install the SNMP Trap Receiver in my local probe but i can't seem to get any link down trap from my switch. My switch is configured to send link down traps to this local probe. As for this sensor setting, i have key in 1.3.6.1.6.3.1.1.5.3 as the OID. I simulated the link down from the switch but no traps recieve.
Any advise what is wrong?
Article Comments
Hello,
please see:
Does the test from PRTG itself work?
best regards.
May, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
please see:
Does the test from PRTG itself work?
best regards.
May, 2011 - Permalink