HTTP Full Page
Modified on 2025-06-10 11:53:32 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I am creating alot of HTTP Full Page sensors and when I am viewing my home page, the URL's are not fully visible. How can I adjust the view settings so that I don't need to click on each sensor to view the full URL?
Thanks,
Jon DeSalvatore
Article Comments
Dear Jon,
which page would be your 'home page' in PRTG? The sensor list?
best regards.
May, 2011 - Permalink
I set my home page from Devices--Group View--Local Probe
May, 2011 - Permalink
I just switched the view from Medium to X-Large and now it shows the full URL's. I guess that works. :)
Thanks
May, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Jon,
which page would be your 'home page' in PRTG? The sensor list?
best regards.
May, 2011 - Permalink