Can I set my percentile report to generate a heatmap or alert?
Modified on 2025-06-10 11:53:51 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I want to run a 99th percentile (over 10secs) daily report on several sensors to smooth bandwith spikes out. However, I then wish to be alerted in some manner - on the PRTG dashboard, via email etc. whenever the generation of that report gives data that exceeds an alert threshold of say 50%.
Can this be achieved?
Thanks
Mark
Article Comments
Hello,
I'm afraid this is not possible.
best regards.
May, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
I'm afraid this is not possible.
best regards.
May, 2011 - Permalink