Are there variables I can use in the Service URL field?
Modified on 2025-06-10 11:55:56 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
We clone a lot of our devices, it would be very helpful if we could put a variable for IP Address in the Service URL field so this would just happen automatically when we clone a device. Is this possible at this time?
Thanks,
Mike
Article Comments
Hello,
I'm afraid that's not possible.
Best regards.
Apr, 2011 - Permalink
Can I make a request to have this included in a future release? It would be very helpful.
Thanks!
Mike
Apr, 2011 - Permalink
Your request has been "registered" (please understand however, I can't promise or guarantee that this will be implemented in a near future release). Thank you for the feedback.
Apr, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
I'm afraid that's not possible.
Best regards.
Apr, 2011 - Permalink