I have a SonicWall TZ200 with a dual wan setup (Cable and DSL). How can I setup PRTG to notify me if either WAN connection goes down? Is there a way to have PRTG send a notification if the WAN goes down for more than X minutes?
Dual Wan monitoring on a SonicWall TZ200
Modified on 2025-06-10 11:58:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
I'm afraid you can only add a state trigger with the latency of "x minutes" on both sensors (one for each interface), where the triggers will then notify you when an interface is down.
Best Regards.
Mar, 2011 - Permalink