Remote probe service restarting frequently?
Modified on 2025-06-10 11:59:26 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I have a remote probe running on an Amazon EC2 Windows 2008 R2 Std x32 instance. There is nothing else on the server. The remote probe starts and then shuts down 15 seconds later, over and over endlessly. On PRTG, the remote probe connects and uploads data but the device turns red and is shown as disconnected causing alarms.
Any ideas?
Article Comments
That worked, thank you.
Feb, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
please have a look at the following article, and see if it helps: PRTG keeps restarting probe service when installed on an Amazon EC2 instance. What can I do?
Best Regards.
Feb, 2011 - Permalink