PRTG clustering and probes
When I install a failover node does the probe need to point to the failover node or the master node
Modified on 2025-06-10 12:00:11 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
the probe of a failover node always has to run as "Local Probe" for the failover node. Otherwise the failover node would not be able to monitor anything.
Best Regards.
Feb, 2011 - Permalink