I'm currently evaluating the PRTG Network Monitor program. I would like to know if there is a way to monitor interface errors on the cisco switches?
I'm currently evaluating the PRTG Network Monitor program. I would like to know if there is a way t
Modified on 2025-06-10 12:00:41 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
have you tried using the "Additional Channels" on SNMP Traffic Sensors (can be enabled in the "Settings" of those sensors), when monitoring the interfaces on the Cisco Switches with such SNMP Traffic Sensors.
Best Regards
Feb, 2011 - Permalink