Can I have a customized map, that shows all the DOWN sensors without the acknowledged ones?
Customized map not showing any acknowledged alarm
Modified on 2025-06-10 12:00:53 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Lukas,
you could simply use the "Data Table"-map object "Down Sensors". This should only show not acknowledged down sensors (please be aware, in case you are running version 8.2.1, there might be a known bug, where also acknowledged sensors are displayed under 'Down', this will be fixed with 8.3, hopefully within the next two weeks).
Best Regards.
Feb, 2011 - Permalink