Which are the minimum hardware requirement for a server to install a Probe that monitor about 500 sensors?
Thanks a lot!
Gianluca
minimum hw requirements for probe
Modified on 2025-06-10 12:02:04 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
it is very hard to name the specific requirements without further details. Please see https://www.paessler.com/prtg/requirements Most likely every up-to-date Dual-Core PC with at least 1GB or RAM will do fine. Harddisk is not important as Remote Probes only write logfiles on disk, everything else is sent to the PRTG Core.
Best Regards.
Jan, 2011 - Permalink