Change Exchange Mail Que WMI Warning setting
Modified on 2025-06-10 12:03:40 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
When I use the default WMI sensors for Exchange 2003 I get a Sensor called Mail Que. It works fine, but I want to change the warning levels of this sensor. In the Moment the Sensors is in warning state when there are more then 1 mails in the que. I want the warning state when there are 10 mail in the que.
Where do I find the number needed for the failure level?
regards
ls
Article Comments
in the sensor settings go to the channels tab, select the desired channel, enable limits. Then add a state trigger in notifications.
Jan, 2011 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
in the sensor settings go to the channels tab, select the desired channel, enable limits. Then add a state trigger in notifications.
Jan, 2011 - Permalink