PRTG 8 - Clarification if I can select what a remote probe monitors. I want to set up a remote probe, to reduce CPU load on core, but want to select what the remote probe monitors. Similar to designated probe for area of network.
How can I select what the remote probe monitors?
Modified on 2025-06-10 12:04:59 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
it simply depends on which devices and sensors you move to the remote probe (in PRTG's web interface).
Best Regards.
Dec, 2010 - Permalink