Would like to have auto-discovered sensors on Cisco switches or routers be named according to the existing port description on the interface. That way, we wouldn't have to re-enter all these port names.....
How can I get auto-discovery to name Cisco switch sensors based upon their existing descriptions?
Modified on 2025-06-10 12:06:03 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Please see How can I change the defaults for names automatically generated for new SNMP sensors?
Nov, 2010 - Permalink