I am getting frequently warning messages "Request Time OUT (ICMP Error #11010)"
ICMP Error #11010
Modified on 2025-06-10 12:06:41 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
supposing you are referring to a Ping-Sensor, this means that the Ping sensor was not able to reach the specified target. This can have several reasons (bad connection, flood-protection, routing problems, etc.). You could try to increase the "Ping Count" in the Settings-Tab of the sensor, this helps with packet loss (the sensor will not go into an error-state if 2 of 10 ping packets per scan are lost). Another option is to use a higher timeout, this would help with a slow connection.
Best Regards.
Nov, 2010 - Permalink