saturation notification
Modified on 2025-06-10 12:08:39 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I need to be notified when sensors are ata certain saturation port on my nods. How do I set up the PRTG to email me when these sensors hti a certain percentage of total bandwdth usage?
Article Comments
Hello,
you could use PRTGs Sensor Factory to calculate the usage in percentages and then use triggers upon this sensor, to alarm upon the percentage usage.
Best Regards.
Oct, 2010 - Permalink
Where do I get the Sensor Factory?
Oct, 2010 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
you could use PRTGs Sensor Factory to calculate the usage in percentages and then use triggers upon this sensor, to alarm upon the percentage usage.
Best Regards.
Oct, 2010 - Permalink