I want to ignore some of the alerts being generated from certain disk volumes and get notified about others on a particular sensor. Can I disable or ignore individual channels of a sensor?
How can I disable alerting for a particular channel of a sensor?
Modified on 2025-06-10 12:09:31 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
if you are working with Error- and Warning Limits on those Disk Sensors, we would suggest not to use the Limits on the 'Settings'-tab of the sensor, but to use the Error- and Warning-Limits in the Channels-Tab of the sensor to do this: PRTG Manual - Sensor and Channel Settings. And then only supply error-limits on those channels were you want to have alarms.
Best Regards.
Jul, 2010 - Permalink