hi,
I have two switches in VRRP, both are active, i need to monitoring which one is in use, is it possible?
Is it possible to configure VRRP?
Modified on 2025-06-10 12:09:58 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The OID 1.3.6.1.2.1.68.1.3.1.3 holds the current state of the device and can take the following numerical values:
So you might want to use the SNMP Custom Sensor in combination with a Lookup.
Taken from http:cric.grenoble.cnrs.fr
PRTGapi | Feature Requests | WMI Issues | SNMP Issues
Kind regards,
Stephan Linke, Tech Support Team
Mar, 2019 - Permalink