PRTG SHARPS
Modified on 2025-06-10 12:11:17 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Good day! I have issue with in PRTG. In image below you can see sharps, and after reboot PRTG sharps disappear but come back again.
It is randomly from different devices. (Cisco) Sometimes appear and disappear. I have checked real load interfaces it is without sharps
https://ibb.co/dtXqfQ3
Article Comments
Both devices configured as 64Bit SNMP
for test i change on one device from " Handle overflow values as valid results" to "Ignore overflow values"
But issue save on both devices.
Both use snmp v2c
There are any ideas?
https://ibb.co/XCzPw6K
https://ibb.co/m6769j2
Mar, 2019 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
Could you check if this is the 32Bit or 64Bit SNMP Traffic Sensor? I assume that you run into the issue explained here:
https://helpdesk.paessler.com/en/support/solutions/articles/76000042348-what-is-the-overflow-values-setting-in-the-snmp-compatibility-options
Best regards
Mar, 2019 - Permalink