Hi!.
I am trying to define a sFLOW sensor using PRTG version 19.1.48.2891 and a core switch Aruba Model 8400. sFLOW Tester receive samples ok, with some errors show in "sample format": 1694 samples from a total of 74519 samples.
But sflow sensor does not receive any data
What could be wrong?
Regards!

Here I show OS config of Aruba Switch:
Model Aruba 8400
SW-BA-CORE-01# sh ver

ArubaOS-CX
(c) Copyright 2017-2018 Hewlett Packard Enterprise Development LP

Version : XL.10.01.0020
Build Date : 2018-09-06 11:57:01 PDT
Build ID : ArubaOS-CX:XL.10.01.0020:f514f45203e2:201809061836
Build SHA : f514f45203e2bb9284f18b7cd2d6cdce627ab337
Active Image : secondary
Service OS Version : GT.01.02.0003
BIOS Version : GT-01-0021

Config

sflow
sflow collector 172.20.0.210 port 5600
sflow agent-ip 172.20.254.1

SW-BA-CORE-01# sh sflow
sFlow Global Configuration

sFlow enabled
Collector IP/Port/Vrf 172.20.0.210/5600/default
Agent Address 172.20.254.1
Sampling Rate 4096
Polling Interval 30
Header Size 128
Max Datagram Size 1400

sFlow Status

Running - Yes

SFlow Statistics

Number of Samples 11346427

Article Comments

Hello Luis,

Thank you for your contact.

Please pause the sFlow sensor within PRTG. This is necessary to prevent the Port from being used while running the sFlow Tester. Afterwards, re-run the sFlow Tester on the same Probe (either Local Probe or Remote Probe) that has the affected sensor, configure the Tester properly and upload the result as screenshot to this thread.

Best regards,
Sebastian


Mar, 2019 - Permalink