Is there a way to have a report for downtime/uptime?
Modified on 2025-06-10 12:14:36 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
I have been trying to find a way to use PRTG for our reports. Every end of shift we need to create a report that shows any server that goes down and for how long. I have had many failed attempts at trying to solve this and I would like some help if possible.
It would be for a 8 and 12 hour period. Just to see anything that went down during the this frame to see how long it was down for and when it came back up.
Thank You!
Article Comments
Hello there,
PRTG can run reports for sensors that were added to a report, but it cannot generate dynamic reports like "Include only sensors that were down during some period". Maybe this here could be useful for you.
Kind regards,
Erhard
Feb, 2019 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello there,
PRTG can run reports for sensors that were added to a report, but it cannot generate dynamic reports like "Include only sensors that were down during some period". Maybe this here could be useful for you.
Kind regards,
Erhard
Feb, 2019 - Permalink