How to disable status "Unsual" on PRTG ?
Can I close the alert?
How to disable status "Unsual" on PRTG ?
Modified on 2025-06-10 12:23:34 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello cmmourinho,
Thank you for contacting Paessler Support.
The unusual detection can be configured globally under Setup > Monitoring > Unusual Detection. Also, it can be disabled/enabled on device-, group-, probe- and root-level under Advanced Network Analysis > Unusual Detection.
Please refer to the links below for further details: - https://www.paessler.com/manuals/prtg/sensor_states - https://www.paessler.com/manuals/prtg/monitoring_settings#unusual
Best regards,
Sven Roggenhofer [Paessler Technical Support]
Nov, 2018 - Permalink