Contradiction in Sensor factory and its Source channels
Modified on 2025-06-10 12:24:08 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Dear Support Team
Sometimes we face these similar issues:
- The aggregated graph (sensor factory) that shows in 2days or 30days tabs, is different from the same period in reports or historic data! (not in all time span of graph but in a part of graph)
- The aggregated graph (sensor factory) that includes 2 sensors that one of them is paused (sensor B) and has no data in last 2 days, should be exactly same as the source channel that has data (sensor A) in last 2 days. but it's not! (not in all time span of 2days graph, just in a part of graph). There is this contradiction in data table of aggregated graph and sensor A too! But if the aggregated graph scrolls an hour, the graph became similar sensor A !! while data tables is different !!!
Kindly thanks for your guidance.
Article Comments
Hello,
Thank you for the KB-Post. Please share some screenshots illustrating the issues. Thank you!
best regards.
Nov, 2018 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Thank you for the KB-Post. Please share some screenshots illustrating the issues. Thank you!
best regards.
Nov, 2018 - Permalink