Hello,
Is it posible to set an channel warning/error only after a multiple repeat of the passed threshold?
Kind regards, Bastiaan
Trigger warning/error only after x times
Modified on 2025-06-10 12:25:10 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Let's say you scan for the error every 5 minutes - you just set the treshhold for the notification to e.g. 3x that much like 15 minutes (aka. 900 seconds)
The Treshhold tricker has a similar setting...
Your state is likely determined by a scan-interval - therefor X amount of time of the interval would be the best way forward, unless you use the API and send data to PRTG - where I tend to say change your code and add a channel or use the business process sensor or sensor factory sensor where you might be able to calculate it out...
Regards
Florian Rossmark
www.it-admins.com
Nov, 2018 - Permalink