Change default scan interval when discovered by autodiscover?
Modified on 2025-06-10 12:25:11 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi Paessler,
We have undertaken a large scale change to scan intervals to make load a bit lighter and metrics a bit more readable. However new ADSL devices are autodiscovering sensors at 30sec interval for ping and 1 min for traffic and health sensors. Is there a way to make it so that by default autodiscover sensors set to 5 mins?
Kindest
Samuel
Article Comments
Hello Samuel,
In this case I would recommend a device template of your own and use this template then to run auto-discoveries where needed.
Kind regards,
Erhard
Nov, 2018 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Samuel,
In this case I would recommend a device template of your own and use this template then to run auto-discoveries where needed.
Kind regards,
Erhard
Nov, 2018 - Permalink