How to use the command line to complete DataExtractor "RUN" button?
How to use the command line to complete DataExtractor "RUN" button
Modified on 2025-06-10 12:29:23 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi Peter,
I'm afraid that the data extractor is deprecated and without further support. The Data Extractor will start as soon as the parameters are copied into the CLI.
Best regards, Felix
May, 2016 - Permalink