When I add an SNMP Bandwith sensor for our central router (bintec), I get an overview of the existing Interfaces. But it seems this overview ist limited to show only 75 Interfaces... is there a way to add the sensortype for Interfaces above a count of 75?
SNMP Bandwidth Sensor shows only 75 of the 106 existing Interfaces
Modified on 2025-06-10 12:43:49 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
In the lower right corner of the table when you try to add the "SNMP Traffic Sensor", you should be able to scroll to another side. The tables now have multiple sides, depending on the amount of objects.
Best regards.
Jul, 2018 - Permalink