Hello, I want to configure PRTG to monitor our cisco switches 3560 and 3750 series in the network like alerts if trunk goes up/down, if switch goes offline. CPU and memory and bandwidth.
Thanks in Advance.
Configure PRTG to Monitor Cisco Switch
Modified on 2025-06-10 13:07:32 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear Samirshk
Please add those switches as devices in PRTG. If you want to add sensors manually, please use the according button and type "Cisco" to filter only for Cisco sensors, like the System Health sensor.
As an alternative, you can perform an auto-discovery on the device and when it is completed, delete all sensors which you don't want to use.
May, 2015 - Permalink