It would be nice to allow for a specific Value of a Sensors Channel be added ONLY to a map.
IE: If I have a map that shows VOIP statistics from firewalls to sip provider showing graphs, I may also have a 2 way QOS sensor where by I would only be interested in just seeing the MOS Channel Value.
Article Comments
Hello,
thank you very much for your KB-Post. Depending on the map object, you can try setting the desired channel to be the primary channel. Some map objects only show the last value of the primary channel.
Otherwise, you could disable the other channels of the sensor to be disabled (in graphs).
best regards.
May, 2014 - Permalink
Hello,
thank you very much for your KB-Post. Depending on the map object, you can try setting the desired channel to be the primary channel. Some map objects only show the last value of the primary channel.
Otherwise, you could disable the other channels of the sensor to be disabled (in graphs).
best regards.
May, 2014 - Permalink