I am monitoring a server using this check. However a raid controller lost a drive and status returns "Warning". In my setup I consider this "Critical"! Can I change it somehow?
Hp Proliant SNMP Raid status
Modified on 2025-06-10 13:46:48 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. Please check the Channel Settings of the Sensor, either change the Error-/Warning-Limits on the sensor, or if the sensor uses a Lookup, please change/edit the Lookup-File.
best regards.
May, 2014 - Permalink