We don't want to notify that the SNTP sensor went down or not. How do we configure PRTG for this condition?
Thanks
How do you configure a sensor to not send a notification when down?
Modified on 2025-06-10 13:47:12 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. Did you already remove / disable all Triggers on the SNTP-Sensor? That should then prevent any notifications.
best regards
May, 2014 - Permalink