Hi guys. We remote monitor several sites, on each site there is a router and connected to each router there is a switch and som other devices. My question is: Can I some how set the alram/notification to not send alarms when the router goes down? (if the router goes down I want it to only show the router alarm, and not a alarm on all devices also connected to the router)
Alarm prio
Modified on 2025-06-10 14:24:24 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. You can use Dependencies to help here. With cascading subgroups, you can set a the subgroup (containing the switch and the other devices, so everything "behind" the router), and then make this group dependent on the Ping Sensor" to the router.
If this ping sensor then fails, the subgroup will be paused, and not send notifications.
best regards.
Apr, 2013 - Permalink