I have a master and one failover node. It doesn't matter which server I connect to I see a probe for the master but not for the failover node. I attempted to add the probe from the failover as a remote probe to the master. I then set it back to being a local probe to the failover but it still shows up as a probe that is disconnected and cannot figure out how to delete it.

I need to get this configured and working properly to demo for our partners.

I also have a problem with one server's sensors the failover node shows all sensors down except for ping and the master shows all sensors up, how can this be.

Article Comments

Hello,

as said, the probe of a failover-node needs to run as Local Probe. Only then the node can collect data and do its monitoring.

Best Regards.


Feb, 2011 - Permalink

I think the question had to do with the visibility of Probe nodes on the failover node, I am having the same issue

we are running 8 probes, I can see them on the master node but I cannot see my probes in the failover node


Mar, 2013 - Permalink

Remote probes can only be seen from the Master node and not from failover nodes, a remote probe can be connected only to one Server and deliver monitoring data there. Best Regards


Mar, 2013 - Permalink