Since updating to 13.1.2 a lot of our custom SNMP sensors are just returning a value of OK instead of the correct response. We can fix this by going into the settings changing the OID value to something then changing it back and everything then works fine. Why is this happening? We have about 6000 sensors and do not want to have to do this for everything single one.
Sensors returning OK
Modified on 2025-06-10 14:28:09 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Please forward an email to support@paessler.com refering to this thread. Please provide screenshots of the issue, as well as of the sensor settings, including screenshots of the informaton available under the "Channels" tab, so that we have a reference as to the configuration of the sensor in case.
Mar, 2013 - Permalink