I was wondering is it is possible to get a report on sensors in a warning state. Basically what I am looking for is similar to the Uptime/Downtime report except I would rather it be Uptime/Warningtime.
I'm not seeing many options on this from the GUI but I have heard that it may be possible through Powershell scripting.
The reasoning for this is that we monitor our MPLS circuits for remote offices by putting the sensors in a downstate if it is down and putting the sensor in a warning state if the bandwidth is saturated. This type of report would be valuable for us to see what circuits are candidates for an upgrade.
Thank you.
Hello,
I'm very much afraid warning states are not transported to reports. So only way I can see is getting the data via the PRTG API, and then calculating this externally.
best regards
Feb, 2013 - Permalink