We wish to monitor our Cisco router with netflow v9. The current active flow timeout for devices are 30mins. If PRTG will only display the statistic upon 30mins, it will be too long as we wish to monitor real time top talker by 10mins example. So would it be advisable for us to set the devices active flow timeout to 5mins or 10mins for this situation?
Active Flow Timeout in Flow sensors
Modified on 2025-06-10 20:44:34 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello there,
we appreciate your contact and inquiry.
Yes, definitively. You can lower the Active Flow Timeout on the device to let's say 4 minutes and then to 5 minutes in the sensor in PRTG. This way you will see the data with only five minutes of delay.
For more details on the subject of Active Flow Timeout, please refer to:
Best Regards,
Luciano Lingnau [Paessler Support]
Feb, 2018 - Permalink