We have a Cisco Switch SG300-52 but i don't reach to configure snmp trap of it on prtg.
SG300 SNMP
Modified on 2025-06-10 21:07:27 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Thank you for the KB-Post. Is SNMP already fully enabled on the switch (see: https://community.spiceworks.com/topic/post/2542130 for example on a how to)?
If so, please use our SNMP Tester, run it on the PRTG Host (or host of the Remote Probe), and perform a "Scan available standard interfaces" against the target device. Which results do you get in the Tester? Please send us the result logfile from the Tester.
Oct, 2017 - Permalink