Cisco WLC MIB
Modified on 2025-06-10 21:14:22 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi,
Anyone has achieved to walk the MIB for Cisco WLC 2504/5508 in PRTG?
I have imported the MIB to PRTG, but when I run the OIDLIB the result is 0.
Thanks in advance
Ruben
Article Comments
Hello,
thank you very much for your KB-Post. Can you please try to use our SNMP Tester run it on the PRTG Host, and perform a scan with the OIDLib against the target device? Which results do you get in the tester?
best regards.
Dec, 2013 - Permalink
Hi there,
If you're looking to monitor a WLC, please have a look here as we have a custom device template for it now:
Best Regards,
Luciano Lingnau [Paessler Support]
Aug, 2017 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. Can you please try to use our SNMP Tester run it on the PRTG Host, and perform a scan with the OIDLib against the target device? Which results do you get in the tester?
best regards.
Dec, 2013 - Permalink