Hi,
We have 2 ISPs in house. Is there any sensor through which I can individually monitor bandwidth usage for both ISPs. I have tried sensors, with IP, Interface and Nexthop. But the results were not what I was looking for. Is there a way can monitor that.
Regards
Sandeep
Article Comments
Hi Sandeep,
The only way I see would be if you have some sort of switch point in your own infrastructure, which would make it possible to differentiate which traffic went through which ISP, like traffic through router A is ISP 1 and traffic through router B is going to ISP 2 or some vlan setup. If that's not the case, then I have no idea PRTG should differentiate it.
Kind regards,
Erhard
Jul, 2017 - Permalink
Hi Sandeep,
The only way I see would be if you have some sort of switch point in your own infrastructure, which would make it possible to differentiate which traffic went through which ISP, like traffic through router A is ISP 1 and traffic through router B is going to ISP 2 or some vlan setup. If that's not the case, then I have no idea PRTG should differentiate it.
Kind regards,
Erhard
Jul, 2017 - Permalink