Dear Friends,
I have installed PRTG and it works ok.
But i have an application installed on server that allows me to add the SNMP address in it and get notifications for the errors it may have.
How can i connect this third party application on the PRTG? Is there a client software that must be installed on the Server that the application is installed?
Thanks,
Constantinos
Connect With 3rd Party Application
Modified on 2025-06-10 21:23:55 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
The application probably sends so called SNMP Traps which can be monitored using the
SNMP Trap Receiver Sensor. Configure the application to send the traps to the PRTG Server in order for the sensor to receive them.
Kind regards,
Stephan Linke, Tech Support Team
Jun, 2017 - Permalink