SNMP Trap Receiver can't add - cluster was remove
Modified on 2025-06-10 21:24:33 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Article Comments
Why would you disable the cluster for this? What actual error do you get when adding the sensor to a device?
Jun, 2015 - Permalink
You can add a the "Sensor SNMP Trap Receiver" to
Root | Local Probe
instead of
Root | Cluster Probe
Jun, 2017 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Why would you disable the cluster for this? What actual error do you get when adding the sensor to a device?
Jun, 2015 - Permalink