Issues cloning Netflow sensor
Modified on 2025-06-10 22:02:40 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi!
I am using the NetFlow V9 Custom sensor to monitor netflow data. I already added a sensor and then tried to clone this.
In my opinition, both sensors should show the same data, shouldn't they?
However, there are huge differences between them.
What is the reason for this?
Here you can se a comparison:
https://i.imgsafe.org/237d42d8b6.png
thanks.
Article Comments
Dear user
The left screenshot does not show on which device (and probe) the sensor is attached to. Is it operating on the same location in the PRTG device tree?
Sep, 2016 - Permalink
It is. But the issue was solved. You simply have to wait for an hour and everything is perfect.
Sep, 2016 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear user
The left screenshot does not show on which device (and probe) the sensor is attached to. Is it operating on the same location in the PRTG device tree?
Sep, 2016 - Permalink