Added new sensor and the interface I want to monitor is showing wrong speed. It is showing 1GB instead of 10. Is there a way for me to change that??
Interface showing wrong speed
Modified on 2025-06-10 22:09:59 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Where is this wrong speed shown? In the settings of an SNMP Traffic sensor? Or in the listed interfaces while adding the sensor? Please let me know what you are referring to.
Kind regards.
Aug, 2016 - Permalink