using prtg network monitor 13 .after 10 day working perfectly my probe heath goes red and by clicking on it it say simulated error pe034. how can i resolve this problem .restarting server doesn't solve the problem and it is still red
how to solve probe health error pe034
Modified on 2025-06-10 22:21:56 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
thank you very much for your KB-Post. You can remove a simulate error on a sensor by right-clicking on the sensor and then selecting Resume from the Context Menu.
best regards.
May, 2014 - Permalink